This Article Full Text (PDF) References Alert me when this article is cited Alert me if a correction is posted Citation Map Services Email this article to a friend Similar articles in this journal Alert me to new issues of the journal Add to Saved Citations Download to citation manager Request Permissions Request Reprints Add to My Marked Citations Citing Articles Citing Articles via HighWire Citing Articles via Google Scholar Citing Articles via Scopus Google Scholar Articles by Slade, J. Articles by Advani, S. G. Search for Related Content Social Bookmarking                         What's this?

Fluid Impregnation of Deformed Preforms

E. M. Sozer

S. G. Advani

Department of Mechanical Engineering, University of Delaware, Newark, DE 19716-3140

The Resin Transfer Molding (RTM) manufacturing process is frequently used to fabricate parts consisting of doubly curved shells. Woven and stitched bi-directional fabrics deform when draped over tooling surfaces with double curvatures. This deformation results in a corresponding change in the preform's permeability tensor, which will change the fluid impregnation pattern during mold filling stage. This paper presents the results of a study in which flow through deformed preforms was investigated. Experiments were conducted in which two different preforms were radially injected after being sheared to a specified angle. The resulting elliptical flowfronts were used to determine the change in the orientation and degree of anisotropy of the permeability tensor caused by the preform's deformation. The experimental results were then compared with a numerical model developed to describe flow through typical RTM preforms using a deformable unit cell. The anisotropy ratio of the principal permeability tensor was found to increase with the shearing angle as observed experimentally and was verified by the numerical model. The success of the RTM mold design and the accuracy of mold filling simulations are dependent on the use of the correct spatial permeability tensor inside the mold. A predictive model that can provide the permeability changes as a function of local shearing deformation within the draped and compacted preforms should move us closer to a realistic simulation of mold filling in net-shaped composite structures.

Key Words: composites • RTM • permeability • preform • architecture • deformation

Journal of Reinforced Plastics and Composites, Vol. 19, No. 7, 552-568 (2000)
DOI: 10.1177/073168440001900703


CiteULike    Complore    Connotea    Del.icio.us    Digg    Reddit    Technorati    Twitter    What's this?

This article has been cited by other articles:

				A. Endruweit and P. Ermanni Orientation of the Permeability Principal Axes in Bi-Directional Textile Fabrics Journal of Reinforced Plastics and Composites, July 1, 2004; 23(10): 1063 - 1073. [Abstract] [PDF]

				A. Endruweit and P. Ermanni Influence of Fixation Structures on the In-Plane Permeability of Unidirectional Glass Fiber Tapes Journal of Composite Materials, August 1, 2002; 36(16): 1993 - 2010. [Abstract] [PDF]

				H. C. Stadtfeld, M. Erninger, S. Bickerton, and S. G. Advani An Experimental Method to Continuously Measure Permeability of Fiber Preforms as a Function of Fiber Volume Fraction Journal of Reinforced Plastics and Composites, July 1, 2002; 21(10): 879 - 899. [Abstract] [PDF]

				H. C. Stadtfeld, M. Erninger, S. Bickerton, and S. G. Advani An Experimental Method to Continuously Measure Permeability of Fiber Preforms as a Function of Fiber Volume Fraction Journal of Reinforced Plastics and Composites, July 1, 2002; 21(11): 879 - 899. [Abstract] [PDF]